iPhone 8 motherboard replacement

Hello everyone, today I show you how to disassemble iPhone 8 and replace motherboard To disassemble the iPhone 8 you need the following tools: • Screwdriver set • Tweezers and opening plastic tool • Plastic mediator • Suction cup for removing display In the description of this video, I left links to the necessary tools and parts for replacement Before disassembling, turn off the iPhone and remove the sim card tray

Unscrew two screws near the lightning port Display glued around perimeter of iPhone and we need to heat the surface of iPhone for open it Apply the suction cup near to the “home” button and pull up on the ring Next, push the plastic mediator between the display and iPhone case From this position, evenly and slowly, open the display around the perimeter of the phone

The iPhone case opens like a book, open the display to the right Next, using a Phillips PH00 screwdriver, unscrew the 4 screws and remove the metal panel First, disconnect the battery cable from the mainboard After that, remove the 2 display cables Next, unscrew the 3 screws and remove the metal panel in the upper case of the iPhone

Disconnect the front camera cable from the mainboard In iPhone 8 uses different sizes of screws, and in order not to confuse them during assembly, I recommend using a magnetic pad Unscrew the 2 screws and remove the metal panel Next, disconnect the camera cable from the mainboard and remove the camera from the iPhone case Unscrew the 2 screws and remove the metal panel

Unscrew the 4 screws and now you can remove the plastic component from the case Unscrew the 2 screws and remove the grounding clip Disconnect the cable Unscrew the 2 screws and remove one more grounding clip Unscrew the last two screws, one of which is hidden under the adhesive tape

Now turn off all remaining cables and remove the motherboard from the iPhone case When you reassembling, pay attention to the size of the screws and fasten them into place Before final assembly, connect the display and check how everything works Remove the old glue from the iPhone case Also, remove the adhesive from the display module

After that, wipe the surface of iPhone case and display module Now take adhesive tape and apply to the case of the iPhone With this tape, you save waterproof resistance of the iPhone Also, I left link to this adhesive tape in description Connect two display cables and front camera cable to the mainboard of iPhone

Install the metal panels and fasten the screws Now close the iPhone case and press down the display around the perimeter

Fasten the two screws near the lightning port Now you can turn on the iPhone and use it